Question: How Much Bleach Should You Put In Your Well?

Is it safe to put Clorox in your well?

You can disinfect your well with household chlorine bleach such as Clorox, Purex or a generic brand.

The chlorine in the bleach kills bacteria.

Note that it may take more than one chlorination for your well to return a satisfactory test..

Can you put too much bleach in a well?

Do not use excessive amounts of bleach – more is not more effective. 5) For best results the bleach should be combined with water before adding it to the well. [By reducing the concentration there is less chance of corrosion of the cables and pipes in the well.

What do I do if I put too much bleach in my well?

To remove the bleach, pump the well water out through a hose attached to a tap (inside or out, but away from the septic system) until you can’t smell the chlorine anymore. Wait three or four days, and test your water. To be safe, Warren recommends you then test it twice more.

How long after bleaching Well can I shower?

24 hoursBefore you chlorinate your well, there are a number of precautions and steps to take to ensure safety for your family. Keep in mind that doing laundry and taking a shower cannot be done for at least 24 hours with a chlorinated well. Waiting a few days to do these is a good idea.

How do you maintain a well?

Keep hazardous chemicals, such as paint, fertilizer, pesticides and motor oil away from your well. Periodically check the well cover or well cap on top of the casing (well) to ensure it is in good repair. Always maintain proper separation between your well and buildings, waste systems, or chemical storage facilities.

How long should you wait to use water after you chlorinate a well?

Use your reserves of fresh water for all purposes. Step 6 WAIT at least 12 hours before turning faucets back on. Do not drink, cook, bathe, or wash with water from your faucets during this time because it has high amounts of chlorine in it.

How long does it take to flush bleach from a well?

30 minutes to 24 hoursRun the water to flush the bleach solution out of the well. Monitor the process, it can take 30 minutes to 24 hours or more to flush all of the bleach solution from the well.

How much bleach should I put in my water tank?

A general rule of thumb to shock chlorinate and disinfect a storage tank is to mix non-scented NSF-approved household bleach (5.25% chlorine) in the reservoir at the ratio of 1 gallon of bleach for every 1,000 gallons of water (i.e., 1 quart for every 250 gallons of water).

How long after shocking a well can you drink the water?

Wait one to two weeks after shock chlorinating the water supply system to retest for total coliform and E. coli bacteria. Follow sample collection instructions carefully. If the test results show the absence of coliform bacteria, the water is safe to drink.

Can you drink water with bleach?

Adding some bleach helps make water safe to use. liquid bleach to 1 gallon (16 cups) of water. 3.Mix well and wait 30 minutes or more before drinking. … After a natural disaster, water may not be safe to drink.

Why does my well water turn brown when I add bleach?

The brown is the iron in the water that has oxidized as a result of the chlorination. Normally, the iron in water is in ion form and does not display itself until it combines with oxygen and forms common rust which turns the water reddish-brown.